Mounting A Poster Diy Clear Away From The Wall

Mount your poster with mod podge on blank canvas.

Mounting a poster diy clear away from the wall.

Spray the back of the poster and the good face of the plywood with the adhesive. Or you could use staples nails or tacks. Visit a local art supply store to see the types of backing that are available or make your own with thin sheets of wood or plastic. To mount a print place it face down on a clean surface.

Lay out your poster and foamcore on newspaper. You want the poster and the plywood to stick to each other but not to the paper. Drill at that spot about halfway through the depth of the wood block. If your photos are still a little curved instead of flat it s a good idea to apply a second row of adhesive all the way around the edges.

Apply adhesive all the way around the edges as close to the edge as possible. Mark a spot at the center of the back side of the block toward the top about 2 inches from the top edge for a standard sized poster if you intend to hand the poster on the wall. Use multiple binder clips to hold posters and photo enlargements or smaller prints like postcards from their edges. Thoroughly spray the foamcore with adhesive.

The best way to hang your posters is to know what not to do first. Leave to dry for 10 minutes. If you want to add dimension to your poster and don t mind a permanent solution try buying a blank canvas from the art supply store and mounting your poster with a gel medium such as mod podge or for the less brave mounting tape or repositionable mounting spray. You could use duct tape.

Because dry mounting is permanent in nearly all cases you need to be certain that you like the appearance of the backing you select. Nobody wants ripped posters and paint being peeled off either. Drill a hole through the tape at each wall hanger marking using a drill bit one size smaller than the wall anchor. If the poster is tightly rolled temporarily hold it down with a few strips of scotch tape.

You can hang them from lines hooks and screws against or away from walls. It should be barely tacky. Spray the back of the poster only if the adhesive manufacturer recommends that both surfaces be coated. But that s a super bad idea because duct tape can get too stuck to your poster and damage your wall.